Helpful Hints And Tips - AEG HG654320 User Manual

4.1 Ignition of the burner
WARNING!
Be very careful when you use
open fire in kitchen environment.
Manufacturer decline any re-
sponsibility in case misuse of the
flame
Always light the burner before
you put cookware.
To light the burner:
1. Push the control knob down and
turn it counterclockwise to the maxi-
mum position (
2. Keep the control knob pushed for
approximately 5 seconds; this will let
thermocouple to warm up. If not, the
gas supply will be interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner
does not light, check if the crown
and its cap are in correct posi-
tions.
A) Burner cap

5. HELPFUL HINTS AND TIPS

WARNING!
Refer to the Safety chapters.
5.1 Energy savings
• If possible, always put the lids on the
pans.
B)
C)
D)
).
A
B
4.2 Turning the burner off
C
To put the flame out, turn the knob to
the symbol
D
• When the liquid starts to boil, turn
Use cookware with diameters applicable
to the size of burners.
Burner crown
Ignition candle
Thermocouple
WARNING!
Do not keep the control knob
pushed for more than 15 sec-
onds.
If the burner does not light after
15 seconds, release the control
knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
In the absence of electricity you
can ignite the burner without
electrical device; in this case ap-
proach the burner with a flame,
push the relevant knob down
and turn it counter-clockwise to
maximum gas release position.
If the burner accidentally goes
out, turn the control knob to the
off position and try to light the
burner again after minimum 1 mi-
nute.
The spark generator can start au-
tomatically when you switch on
the mains, after installation or a
power cut. It is normal.
.
WARNING!
Always turn the flame down or
switch it off before you remove
the pans from the burner.
down the flame to barely simmer the
liquid.
Burner Diameters of cook-
Rapid 180 - 260 mm
ENGLISH
7
ware