TABLE OF CONTENTS
SECTION 2. MEETING CODES .............................................................................................................................. 3
SECTION 5. CONDENSATE DRAIN.......................................................................................................................14
SECTION 21. CHECKING CONTROLS ..................................................................................................................25
SECTION 1. IMPORTANT SAFETY
RULES
To alert you to potential hazards, we use the signal words
"WARNING" and "CAUTION" throughout this manual.
"WARNING" alerts you to situations that could cause or
result in serious injury or death. "CAUTION" alerts you to
situations that could cause or result in minor or moderate
injury or property damage.
installation be sure to read and follow all warnings and
cautions.
We also use the words "must" and "should" in this manual.
"Must" is mandatory. "Should" is advisory.
WARNING: Read and follow the safety rules in
this section and throughout this manual. Failure to do so
could cause improper fu rnace operation, resulting in
damage, injury or death.
Rule 1. Use only gas approved for use in this fu rnace, as
indicated on furnace rating plate. Use only natural gas in
furnaces designed for natural gas. Use only propane (LP)
gas in furnaces designed for propane (LP) gas. Make sure
furnace will operate properly on the gas type available to
user. Do not use butane gas in this fu rnace.
Page 2
.............................................................................................................................27
For a safe and reliable
WARNING: Use of a non-approved gas (such as
butane) in this furnace could cause sooting or overheating
of heat exchanger.
Rule 2. Do not install this fu rnace outdoors or in a mobile
home, trailer or recreational vehicle.
certified for these installations. This furnace is suitable for
a home built on site or a manufactured home completed at
the final site.
Rule 3. Air for combustion must not come from a corrosive
or contaminated atmosphere. Make sure all combustion
and ventilation air requirements are adhered to in addition
to local codes and ordinances.
Rule 4. This furnace is not to be used for temporary
heating of buildings or structures under construction.
Rule 5. Provide adequate combustion and ventilation air to
space where furnace is being installed unless combustion
air is provided directly through an inlet air pipe. Connect
this
furnace to an approved vent system--venting
combustion products outdoors.
Rule 6. Check for gas leaks anytime work is done on gas
supply line, furnace gas control, pilot and pilot line or main
burner manifold.
Rule 7. Never test for gas leaks with an open flame. Use a
commercial soap solution made specifically for leak
detection to check all connections.
It is not design
Installer's Information Manual