Selecting The Signal Connectors; And Cable; Removing The Monitor Base - HP f2304 User Manual

Å
WARNING: Burn-in image damage may occur on monitors that
display the same static image on screen for a prolonged period of
time. To avoid burn-in image damage on your monitor screen, you
should always activate a screen saver application or turn off the
monitor when it is not in use for a prolonged period of time.

Selecting the Signal Connectors

and Cable

There are five signal input connectors: one VGA connector,
one DVI-I connector, one S-video connector, two RCA audio
connectors, and a PC Audio In connector. The monitor will
automatically determine at power-on which inputs have valid
video signals. The inputs can be selected via the On-Screen
Display (OSD) feature or by pressing the Input button on the
monitor's front bezel.
The video mode supported by the DVI-I connector is
determined by the video cable used. For digital operation,
use the DVI-D to DVI-D signal cable provided.

Removing the Monitor Base

You can remove the monitor base to mount the monitor on a
wall, swing arm, or other mounting fixture. Read the caution
and warning statements below before beginning the
procedure.
Ä
CAUTION: Before beginning to disassemble the monitor, be sure
the monitor is turned off and the power and all signal cables are
disconnected.
Å
WARNING: Before removing the base from the monitor, lay the
monitor flat with the front bezel down. Attempting to remove the
base from an upright monitor may result in injury to the user.
User's Guide
Setting Up the Monitor
3–5