Electronic Adjustment; Filling The Salt Container - Electrolux ESL 6610RO User Manual

German
degrees
(°dH)
< 4
1) Factory setting.
2) Do not use salt at this level.

Electronic adjustment

1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to "Set-
ting and starting a program".
2. Press and hold, at the same time,
Program and MyFavourite until the
indicators of Delay, Program and My-
Favourite start to flash.
3. Press Delay.
• The indicators of Program and My-
Favourite go off.
• The indicator of Delay continues to
flash.

6.2 Filling the salt container

Water hardness
French mmol/l
degrees
(°fH)
< 7 < 0.7
Clarke
degrees
< 5
• The acoustic signals operate, e.g.
five intermittent acoustic signals =
level 5.
• The display shows the current set-
ting of the water softener, e.g.
= level 5.
4. Press Delay again and again to
change the setting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt contain-
er (only for the first time).
3.
Fill the salt container with dishwasher
salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out from
the salt container when you fill it.
Risk of corrosion. To prevent it,
after you fill the salt container,
start a program.
ENGLISH 11
Water softener
adjustment
Electronic
2)
1