Table of Contents
Advertisement
before plugging in
Make sure your electricity supply is the same as the
one shown on the underside of the appliance.
Important – UK only
The wires in the cord are coloured as follows:
Green and Yellow = Earth, Blue = Neutral, Brown =
Live.
The appliance must be protected by a 13A approved
(BS1362) fuse.
WARNING: THIS APPLIANCE MUST BE
EARTHED.
Note:
For non-rewireable plugs the fuse cover MUST be
refitted when replacing the fuse. If the fuse cover is
lost then the plug must not be used until a
replacement can be obtained. The correct fuse cover
is identified by colour and a replacement may be
obtained from your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it must be
DESTROYED IMMEDIATELY. An electric shock hazard
may arise if an unwanted non-rewireable plug is
inadvertently inserted into a 13A socket outlet.
This appliance conforms to EC directive 2004/108/EC
on Electromagnetic Compatibility and EC regulation
no. 1935/2004 of 27/10/2004 on materials intended
for contact with food.
key
1
filler cap
2
lid
3
goblet
4
sealing ring
5
blade unit
6
blade base
7
Power On indicator
8
speed + pulse control
9
power unit
k
drinks programme button
l
soups programme button
m
ice crush programme button
n
fine chop programme button
o
coarse chop programme button
p
rinse programme button
q
vents
r
stir stick
s
cord storage device
to use your blender
1 Fit the sealing ring
the seal is located correctly in the grooved area. Then
fit the blade unit into the goblet
Leaking will occur if the seal is damaged or
incorrectly fitted.
2 Screw the blade base
the blade assembly is fully tightened. Refer to the
graphics on the side of the blade base as follows:
- unlocked position
- locked position
3 Put your ingredients into the goblet.
4 Fit the filler cap to the lid and push down to secure.
5 Fit the lid by pushing down until secure.
6 Place the blender onto the power unit.
Ensure the cord is fully unwound from the
cord storage device before using the
blender.
The appliance will not work if the blender is
incorrectly fitted.
7 Plug in and the Power On indicator
Note: The Power On indicator will flash if the goblet is
not fitted to the power unit. Select a speed (refer to
the recommended speed chart).
8 Choose one of the following options:
Programme buttons:- Turn the speed control to the
'On' position and all the buttons will light up. Press
the required programme button and the lights on the
other buttons will go out and the programme will
start. The blender will switch off automatically at the
end of the programme time. If you wish to stop before
the programme time has elapsed, press the selected
programme button again.
Manually selected a speed by turning the speed
control until the required speed is reached. At the end
of blending return the speed control to "O" before
removing the blender.
Do not remove the goblet until the blades
have stopped rotating and the speed control
is in the 'O' position.
(P) Pulse – operates the motor in a start/stop action.
The pulse will operate for as long as it is held in
position.
Refer to the troubleshooting section if you
experience any problems with the operation of
the blender.
5
4
5
into the blade unit
3
6
onto the goblet – ensuring
7
will light up.
- ensuring
Advertisement
Table of Contents
