Switching The Server On And Off - Fujitsu PRIMERGY TX120 S2 Operating Manual

Starting up and operation
5.3

Switching the server on and off

V
CAUTION!
If nothing appears on the screen but flickering stripes after switching on
the server, switch the server off immediately (see section
stripes on monitor screen" on page
The On/Off button does not disconnect the server from the mains. To
disconnect from the mains completely, remove the power plug(s).
Switching the server on
The power-on indicator (item 7 in
– Starting up for the first time:
Ê Press the On/Off button (item 4 in
The power-on indicator lights green (item 7 in
Ê Insert the PRIMERGY ServerView Suite DVD 1 in the DVD drive.
Ê Follow the on-screen instructions (see also
onboard SATA controller" on page 55
and installing the operating system without the ServerView Installation
Manager" on page
– System already installed:
Ê Press the On/Off button (item 4 in
The power-on indicator lights green (item 7 in
The server is switched on, performs a system test and boots the
operating system.
TX120 S2
63).
figure 10 on page
figure 10 on page
58).
figure 10 on page
Operating manual
Switching the server on and off
48) lights orange.
48).
figure 10 on page
section "Configuring the
or section "Configuring the server
48).
figure 10 on page
"Flickering
48).
48).
53