Hints And Tips - Zanussi ZCG563 User Manual

Hide thumbs Also See for ZCG563:
Table of Contents

Advertisement

Turn the control knob to the off position. This is
shown by a dot. Turn knob clockwise until dot
position is reached. Do not attempt to turn the burner
off by turning the knob counter-clockwise.
!
WARNING!
When lighting any burner, ensure that it is lit before
you leave the appliance. When turning off a burner,
ensure the flame has gone out before leaving the
appliance.
IMPORTANT!
If you are having any difficulty lighting a hob burner
turn all the hob controls off and make sure the burner
parts have been replaced correctly.

Hints and tips

• Do not overfill pans or they will boil over.
• Do not use pans with very heavy handles, which
cause the pan to tip.
• The hob surface should be allowed to cool before
closing the lid.
!
WARNING!
Place pans on the centre of the burners. Position
pans so the handles cannot be accidentally knocked
or overhang the appliance. Lift pans on and off the
pan supports. Do not slide them across the hob.
• Any spillage should be removed from the lid before
opening.
• Do not leave accidental spillage on the hob or
removable parts. The spillage should be wiped up
and the parts washed and carefully dried as soon
as the hob, pan supports and burner parts are cool
enough to touch.
• A flat-based Wok will stand stable on the pan
supports. If you use a round Wok with a collar
support, the collar must be the open wirework type
otherwise the performance of the burner will be
affected.
!
WARNING!
Take care to avoid burns and scalds when reaching
across the hotplate.
!
WARNING!
Take extra care when deep fat frying, do not cover
the pan with a lid. Do not leave a pan unattended. If
the pan catches fire, leave it where it is and turn off
all controls. Place a damp cloth or a fitting lid over the
pan to smother the flames. Never put water on the fire.
Leave to cool for 30 minutes.
!
WARNING!
Do not use the lid as a work surface or chopping
board. This could damage the glass and reduce
it's strength.
!
WARNING!
Gas flame safety device (FSD) is used for cutting off
the gas feed to the burners in case the flames are
accidentally put out by wind, overflowing liquids, etc.
To activate this feature, press the knob during ignition,
and when the ignition occurs, keep it pressed for 5
seconds, but no longer than 10 seconds. When the
flame is accidentally put out, the device will cut out the
gas flow.
!
WARNING!
For your safety, the glass hob lid is equipped with a
safety valve that will cut out the gas feed to the hob
burners in case the lid is lowered. However, the oven
and grill burners will continue to operate regardless of
the position of the hob lid. This function must not be
used for controlling the burners.
Gas hob off
Gas hob on
A
Shut off mechanism
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents