Haier HL19SL2 Owner's Manual page 7

Precautions
As strong light may interfere the signals, change your
position to operate the remote controller if the television
cannot be turned on or off as you expect.
Keep the remote controller away from heat source
or humid area to ensure effective performance of the
remote controller.
Remote control
The remote control cannot be operated unless the batteries are properly loaded.
When using the remote control, aim it at the remote sensor on the TV.
1
2
3
4
5
6
7
8
9
10
11
12
13
Downloaded from www.Manualslib.com
1 PICTURE
14
PICTURE AUDIO
2 ARC
15
3 CCD (closed caption)
ARC CCD MTS/SAP SLEEP
16
4 INPUT
17
5 MENU
6
18
7 EXIT
8 USB
19
INPUT
9 USB PLAY/PAUSE
MENU MUTE
20
0 USB fast reverse
CH+
A USB fast forward
21 B DISPLAY
VOL- VOL+
ENTER
C GUIDE
CH-
D Power
EXIT RECALL
22
E AUDIO
USB PLAY/PAUSE STOP REPEAT
23 F SLEEP button
24
REV PREV NEXT
G MTS/SAP
25
DISPLAY GUIDE FAVORITE CH.LIST 26
H Number buttons
27
28
I
J MUTE
K ENTER
L RECALL
(For TV without DVD)
M USB REPEAT
Color buttons
N USB STOP
Red Green Blue
Yellow
O USB Next Chapter
UP DOWN LEFT RIGHT
P USB Previous Chapter
When functions are attached to the
Q CH.LIST
color buttons, the color buttons are
shown on screen.
R FAVORITE
manuals search engine
Make sure that two AAA alkaline batteries are loaded.
The batteries must be of the same type. The batteries
must be located properly. The batteries are not
rechargeable.
Make sure that there is no obstacle between the remote
controller and television set.
Press repeatedly to cycle through the available picture modes
Select the aspect ratio
Select a closed caption option
Show the input source
Press to open the on-screen menu
Thumbstick (Up/Down/ Volume/Channel Selection, Allows you to navigate the on-screen
Left/Right) menus and adjust the system settings to your preference.
Clears all on-screen displays and returns to TV viewing from any
menu
Press to switch input source to USB in
Press to display the TV status information on the top of the TV screen
Display the guide when you are watching analog or digital channels
Press to turn on and off the TV
Press to cycle through different sound settings
Press to display the sleep timer option
Select MONO, STEREO, SAP in NTSC system
Press to change a channel
Press to select digital channels. For example, to enter "54-3",
Switches the sound on or off
Accesses the highlighted item in the on-screen menu
Press to jump back and forth between two channels
Open the channel list in TV
Open the favourite channel list in TV
Introduction
Haier LED HDTV EN-6