Connecting A Computer; Cable Tv Setup - Haier HL19SL2 Owner's Manual

Installation

Connecting a computer

How to connect
A
To get the best picture quality, adjust the VGA
graphics card to 1024 768.
B
Use the TV's VGA or DVI (Digital Visual Interface)
Audio IN port for audio connections, depending on
your computer connector.
If the graphic card on the computer does not
output analog and digital RGB simultaneously,
connect only one of either VGA IN or HDMI IN to
display the VGA on the TV.
If the graphic card on the computer does output
analog and digital RGB simultaneously, set the TV
to either VGA or HDMI; (the other mode is set to
Plug and Play automatically by the TV.)
C
Then, make the corresponding audio connection.
If using a sound card, adjust the VGA sound as
required.
How to use
A
Turn on the computer and the TV.
B
Use INPUT on the remote control to select VGA or
HDMI source.
C
Check the image on your TV. There may be noise
associated with the resolution, vertical pattern,
contrast or brightness in VGA mode. If noise
is present, change the VGA mode to another
resolution, change the refresh rate to another rate
or adjust the brightness and contrast on the menu
until the picture is clear. If the refresh rate of the VGA
graphic card can not be changed, change the VGA
EN-9
Downloaded from www.Manualslib.com
PC IN
PC/DVI AUDIO IN
Haier LED HDTV
manuals search engine
graphic card or consult the manufacturer of the VGA
graphic card.
Note
Use a DVI cable.
Avoid keeping a fixed image on the TV's screen
for a long period of time. The fixed image may
become permanently imprinted on the screen.
The synchronization input form for Horizontal and
Vertical frequencies is separate.
Resolution
Mode Resolution
VGA 640 480
SVGA 800 600
XGA 1024 768

Cable TV Setup

After subscribing to a cable TV service from a local
provider you can watch cable TV programming. The TV
cannot display TV programming unless a TV tuner
device or cable TV converter box is connected to the TV.
For further information regarding cable TV service,
contact your local cable TV
service provider(s).
Connection Option 1
A
Select 3 or 4 with channel switch on cable box.
B
Tune the TV channel to the same selected output
channel on cable box.
C
Select channels at the cable box or with the cable
box remote control.
Connection Option 2
A
Connect the audio and video cables from the Cable
Box's output jacks to the TV input jacks, as shown in the
figure.When connecting the TV to a Cable Box, match
the jack colors (Video = yellow, Audio Left = white, and
Frame
frequency
(Hz)
60Hz
60Hz
75Hz
60Hz
75Hz