Rear Panel Dip Switches - JVC DV-180 Operation Manual

5.5

REAR PANEL DIP SWITCHES

The function of the DV-180 Controller set-up switches are shown below. To activate any of these
commands, verify the PAGE led is not illuminated, put the desired command DIP switch in the DOWN
position, depress the CAMERA SELECT switch and then depress and release the AUXILIARY 1 switch
as described in the tilt example. Switches 3 – 6 are unused and should remain "OFF".
1 2
R P DIP S
EAR ANEL WITCH
The Function of each of these switches is as follows:
SW8 Pan Reverse
•
Up: Normal pan direction, left on joystick camera pans to the left.
•
Down: Reverse pan direction, left on joystick camera pans to the right
SW7 Tilt Reverse
•
Up: Normal tilt direction, up on joystick camera tilts up.
•
Down: Reverse tilt direction, up on joystick camera tilts down.
SW2 Speed Range 1
SW1 Speed Range 0
•
The Speed Range bits are used to the vary the speed of the joystick and seesaw controls. With both
switches Up the maximum speed is enabled and with both switches down the minimum speed is
enabled
JVC DV-180 PAN/TILT Operations Manual
3 4 5
ON
6 7 8
12
Pan Reverse
Tilt Reverse
Reserved
Reserved
Reserved
Reserved
Speed Range 1
Speed Range 0
Doc #: D0154-A