Adding Or Removing An Fc Switch - HP B6191-90029 User Manual

Special Procedures
Fibre Channel Switch Monitor
Configuring the FC Switch Monitor Configuration File
To configure the FC switch monitor configuration file complete the following steps:
Step 1. Determine which switches you want the monitor to be responsible for. Record the IP address for
each of these switches.
Step 2. Open file /var/stm/config/tools/monitor/dm_fc_sw.cfg in an ASCII text editor.
Step 3. Add the following line to the file:
SW_COUNT n
Replace "n" with the value that reflects the number of switches for which the monitor will be
responsible. For example, the following line would monitor 5 switches:
SW_COUNT 5
Step 4. Add the following line to file:
SW_ X _IP_ADDRESS nn.nn.nnn.nnn
Change the placeholder "X" to the number 1, and replace the "nn" fields with the IP address of the
switch that will be designated as switch 1.
The completed line will look similar to the following:
SW_1_IP_ADDRESS 15.43.214.101
Step 5. If multiple switches will be monitored, replicate the line from step 4 for each switch, changing the
switch number and IP Address for each. When you are done, the number of lines should equal the
number defined in the SW_COUNT setting. For example, the following lines would configure the
monitor for three switches:
SW_COUNT 3
SW_1_IP_ADDRESS 15.43.214.101
SW_2_IP_ADDRESS 15.43.214.171
SW_3_IP_ADDRESS 15.43.214.184
Step 6. Save the file.
Step 7. To invoke the changes made to the switch configuration file, you must use the Enable Monitoring
option of the Hardware Monitoring Request Manager, even if monitoring is already enabled. The
Enable Monitoring option runs the startup client, which reads the contents of the configuration file
and starts the switch monitor to begin monitoring of the FC switches. See "Enabling Hardware
Event Monitoring" on page 42, for more information.
There are other settings in the configuration file that can be changed to customize the operation of the FC
switch monitor. These settings are defined in Chapter 5, "Hardware Monitor Configuration Files."

Adding or Removing an FC Switch

Adding or removing a switch from the monitor configuration involves changing the same configuration file
settings described in the preceding procedure, SW_COUNT and SW_X_IP_ADDRESS.
Changing the FC Switch Monitoring Configuration
To change the FC switch monitoring configuration compete the following steps:
134
Chapter 6