Troubleshooting - Haier HD70-A82 User Manual

TROUBLESHOOTING

Before contacting the customer service, please check the following
circumstances:
PROBLEM CAUSES
Tumble dryer – Poor connection to the
fails to operate. power supply.
– Power failure.
– No drying program is set.
– Device has not been
switched on.
– The water tank is full.
– The door is not closed
properly.
Tumble dryer – The laundry has reached
fails to operate the condition defined by
and the display the program.
shows END.
– There is no laundry in the
drum.
Drying time is – The program setting is not
too long and correct.
the results are
– The filter is clogged.
not satisfac-
– The evaporator is blocked.
tory.
– The tumble dryer is
overloaded.
– The laundry is too wet.
– The vent duct is blocked.
Remaining time The remaining time will be
on the display adjusted continuously based
stops or skips. upon the following factors:
– Type of laundy.
– Loaded amount.
– Moisture degree of the
laundry.
– Ambient temperature.
20 | English
SOLUTION
Check connection to the power
▪
supply.
Check the power supply.
▪
Set a drying program.
▪
Switch the device on.
▪
▪ Empty the water tank.
Close the door properly.
▪
▪ Check if the program setting is
appropriate.
▪ Check if there is laundry in the
drum.
Make sure the program is set
▪
correctly.
Clean the filter screen.
▪
Clean the evaporator.
▪
Reduce the amount of laundry.
▪
Spin the laundry properly
▪
before drying.
Check the vent duct and
▪
unblock it.
The automatic adjustment is a
normal operation.