Mount Into The Dashboard - Philips CEM2101 User Manual

1 Green/black Left speaker (Rear)
strip
2 White/black Left speaker (Front)
strip
3 Gray/black Right speaker (Front)
strip
4 Purple/black Right speaker (Rear)
strip
e Red Ignition key +12V DC when
ON/ACC
f Blue Motor/electric antenna relay
control lead
g White-edged Amplifier relay control lead
blue strip
h Black Ground
i Yellow To the +12V car battery
which is energized at all
times
3
Connect the antenna and amplifier as
illustrated, if applicable.
8 EN
Connector
1 ANTENNA
2 REAR LINE OUT R
(Socket)
3 REAR LINE OUT L
(Socket)
4 OE REMOTE (Purple)
Tip
•
The pin arrangement for the ISO connectors depends
on the type of vehicle you drive. Be sure to make
proper connections to prevent damage to the unit.

Mount into the dashboard

1
If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
• If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
• If the car battery is not disconnected,
to avoid short-circuit, ensure that the
bare wires do not touch each other.
Connect to
Antenna
Rear right
speaker
Rear left speaker
OE Remote