Mounting The Phone To The Wall - Cisco 7970 Setting Up

Adjusting the Placement of the Cisco IP Phone

Mounting the Phone to the Wall

Step 1
Step 2
Step 3
Step 4
Cisco IP Phone 7970 Administration Guide for Cisco CallManager 3.3
3-12
You can mount the Cisco IP Phone on the wall using the footstand as a mounting
bracket or you can use special brackets available in a Cisco IP Phone wall mount
kit. (Wall mount kits must be ordered separately from the phones.) If you attach
the phone to a wall using the standard footstand and not the wall mount kit, you
need to supply the following tools and parts:
Screwdriver
•
Screws to secure the Cisco IP phone to the wall
•
Use the following procedure to mount the phone on the wall using the standard
footstand. See Figure 3-2
Before You Begin
To ensure that the handset attaches securely to a wall-mounted phone, remove the
handset wall hook from the handset rest, rotate the hook 180 degrees, and reinsert
the hook. Turning the hook exposes a lip on which the handset catches when the
phone is vertical. For an illustrated procedure, see Installing the Wall Mount Kit
for the Cisco IP Phone.
Procedure
Push in the footstand adjustment knob.
Adjust the footstand so it is flat against the back of the phone.
Insert two screws into a wall stud, matching them to the two screw holes on the
back of the footstand.
The keyholes fit standard phone jack mounts.
Hang the phone on the wall.
Chapter 3
for a graphical overview of this procedure.
Setting Up the Cisco IP Phone
OL-4314-01