Getting Started; Loading The Battery; Charge Your Battery; Inserting And Removing An Sd Card - HP T500 User Manual

Hewlett-packard camcorder user manual
Hide thumbs Also See for T500:
Table of Contents

Advertisement

2. Getting Started

2.1 Loading the Battery

Before using the camera, users must load the Lithium-ion
rechargeable battery included within the package.
1.
Insert the battery according to the correct polarity marks ( + or -).
2.
Close the battery cover firmly.
Note
If the camcorder does not power up, make sure that it is orientated
properly.

2.2 Charge your battery

It is recommended that the AC adaptor and USB cable included with
the camcorder be used for the initial charge.
The camera must be turned OFF; blinking light confirms charging, and
the light becomes constant when the charging has been completed.
In AC charging Mode, the light will turn itself off automatically after
3~5 minutes . The full charge time is about 4 to 5 hours. (Actual
charging time may vary depending on the condition of the battery.)

2.3 Inserting and Removing an SD Card

Although the camera comes with internal memory which allows a
limited number of photos and video to be recorded, it is strongly
recommended that you expand the capacity by using SD/SDHC
memory cards.
1.
Insert the memory card into the slot. Please refer to the figure on
the right side.
2.
To remove an installed SD card, press the card inwards to release it.
3.
When the card pops out, gently remove it from its slot.
4.
Recommended memory capacity: 1GB or above.
Note
When a memory card is installed, videos/photos are saved
on the card rather than on the built-in memory.
Protecting Data on an SD Card: SD Card is read-only when
it is locked. No photos or videos can be recorded when the
SD card is locked. Make sure the lock is on the writeable
position before recording any media.
Writeable
position
8
Write-Protected
Position

Advertisement

Table of Contents
loading

Table of Contents