Table of Contents
Advertisement
26 www.aeg.com
10.1 Shelf supports
Removing the shelf supports
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
Valid for telescopic runners:
The retaining pins on the tele-
scopic runners must point to the
front.
10.2 Lamp
WARNING!
There is a risk of electrical shock.
The lamp and the lamp glass
cover can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the
interior of the appliance. It pre-
vents damage to the lamp glass
cover and the cavity.
Always use the same lamp type.
2
1
You can remove the shelf supports to
clean the side walls.
1.
Pull the front of the shelf support
away from the side wall.
2.
Pull the rear end of the shelf sup-
port away from the side wall and re-
move it.
Replacing the lamp at the cavity
ceiling:
1.
Turn the lamp glass cover counter-
clockwise to remove it.
2.
Clean the glass cover.
3.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
4.
Install the glass cover.
10.3 Oven ceiling
You can fold down the heating element
on the oven ceiling to clean the oven
ceiling easily.
WARNING!
Deactivate the appliance before
you fold down the heating ele-
ment. Make sure that the appli-
ance is cold. There is a risk of
burns.
Folding down the heating element
1.
Remove the shelf supports.
Advertisement
Table of Contents
