Power Connector Cable - HP Spectre 13 Pro Ultrabook Maintenance Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Bottom cover (see
b. Battery (see
c.
WLAN module (see
d.
Fan (see
e.
System board (see
Remove the power connector cable:
1. Remove the Phillips PM2.0×3.0 screw (1) that secures the power connector cable to the computer.
2. Lift the bracket from atop the connector (2).
3. Lift the connector straight up and out of the computer (3).
Reverse this procedure to install the power connector cable.
Bottom cover on page
Battery on page 46)
WLAN module on page
Fan on page 41)
System board on page
29)
32)
48)
Component replacement procedures
Spare part number
744362-001
51