❿ After Use - NEC M362W User Manual

Dlp projector
Hide thumbs Also See for M362W:
Table of Contents

Advertisement

❿ After Use
Preparation: Make sure that the projector is turned off.
1. Unplug the power cord.
2. Disconnect any other cables.
• Remove the USB memory if it is inserted into the projector.
3. Retract adjustable tilt foot if extended.
(M402W/M362W/M322W/M402X/M362X/M322X/M282X only)
4. Slide the lens cover to the left to cover the lens.
5. Put the projector and accessories in the supplied soft case.
Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens from
damage.
Insert the projector with the lens
facing upward
NOTE: When placing the projector in the soft case, retract the tilt foot and the rear feet. Failure to do so may case damage to the
projector.
(M352WS/M302WS/M322XS only)
4. Reattach the lens cap
1
① Put the lens cap on the top of the lens.
② Push to cover the lens completely.
CAUTION:
Use caution when putting the projector in the soft case immediately after the projector has been operating. The
projector cabinet is hot.
2
30
2. Projecting an Image (Basic Operation)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents