1. Cable Ends: Inspect end fittings daily for wear. Replace cables at the first sign of wear or
on an annual basis. If the cable tension has been adjusted, be certain that the cable nut
is tight.
2. Nuts, Bolts, and Fasteners: Check tightness weekly. If any hardware has become loose,
retighten and/or use Loctite
3. Frames: Wipe all machines down with a damp cloth and dry completely each day. This
includes painted parts, chrome parts and upholstered pads.
4. Painted and chrome plated parts: Use Simple Green or similar cleaner for light dirt and
grime. Use Turtle Wax Polishing Compound or a good car polish to remove heavier dirt
and grease as well as for polishing. DO NOT use solvents, lacquer thinner, acetone or
finger nail polish remover. For scuffs and marks that are not removed by the above
methods use a soft scrub cleanser. Make sure all parts are dry upon completion.
5. Weight stack enclosures (shrouds): Wipe down with a damp cloth as needed.
6. Exercise instruction labels: Clean with soap and water as needed.
7. Guide rods: Wipe all dirt and dust from the guide rods before applying a light application
of Tri-Flow
the guide rods with the rag. DO NOT use oil lubricants such as WD-40. Caution: Tri-Flow
will stain carpet and clothing.
8. Bronze bushings: Check monthly for signs of wear and replace as needed. Lubricate
monthly with Tri-Flow
9. Please refer to the General Maintenance Manual (part number: AM-GMM) for other
important safety and maintenance information.
10. Hardware and components are indicated with a balloon. Refer to the hardware tables
that accompany each step for corresponding size and type.
11. Be sure all hardware is tight before using the machine.
DO NOT install any fitness equipment near a pool, hot tub or other damp locations. Corrosion
!
caused by installation in these locations can lead to premature failure of components.
After you have unpacked and inventoried all of the components, read through the
!
remainder of the assembly instructions to familiarize yourself with the assembly
procedure!
Each step will require the components shown in the table associated with the step.
Read the instructions for each step before assembling.
G
ENERAL
TM
brand Threadlocker 242.
TM
or other teflon spray lubricant. Spray the Tri-Flow
TM
.
C
ARE AND
5
M
AINTENANCE
TM
on a rag and then wipe
TM