Power Connection; Network Connection - Apacer Technology AL460 User Manual

Power Connection

1. Make sure the power switch is off.
2. Connect the DC jack of the AC adapter to the connector marked "DC 12V", plug the
other end into an electrical outlet.

Network Connection

1. Connect one end of the Ethernet cable to the player's LAN connector.
2. Connect the other end of the Ethernet Cable to your networking device.
Power on/off
1. Power on
Press the power switch which is located on the back of the device. After the player is on,
the power indicator on the front panel will light up. The device will then boot to the media
player's user interface.
2. Power off
Press the power button on the remote control. The user interface of the media center
will be off, but the unit will still be on. This is indicated when the power led light is red.
Press the power switch that is located in the back of the device to turn off the device
completely.
Note: If the setting of the video output is incorrect, the TV screen will not display normally.
Switch to correct setting by pressing the
10
button to switch output TV system.