Connecting The Server To The Mains - Fujitsu PRIMERGY TX100 S3 Core Edition Operating Manual

5.4

Connecting the server to the mains

The server is equipped with an integrated power supply unit.
V
CAUTION!
The server is automatically set to a mains voltage in the range
100 V - 240 V. You may only operate the server if its rated voltage range
corresponds to the local mains voltage.
Ê Connect the power cord to the server power supply unit.
Ê Connect the mains plug to a grounded mains outlet in the in-house power
supply network.
Securing the power cord
Figure 3: Securing the power cord
Ê Loop the cable past the cable tie mounting bracket as shown.
Ê Close the cable tie around the power cord (1) and pull tight (2) to secure the
power cord.
TX100 S3 Core Edition
Operating Manual
Hardware installation
41