Setting the Interference Eliminator Code
To set the code, press \ twice until the code number display begins
to blink. Then press [ or ] to set the code. Press
code setting. To hear everyone on your channel, select code
You can specify a different code for each channel. To set a channel and code
combination, press \ and then press [ or ] to select the channel. Press \
again and then press [ or ] to select a code. Press M to exit the menu and to
save the channel and code combination. To set another channel and code
combination, repeat these steps.
Volume
You can set the volume whenever you are not using a menu. Press
[ or ] until it's just right. The display will show
) with
setting (
to
20
1
highest volume.
Caution: Do not hold the radio too close to your ear when the volume is at a high
setting. This could cause hearing damage.
being the lowest volume and being the
1
to save the
M
.
0
and the volume
5
29