Table of Contents
Advertisement
o
Connecting the Power Terminal
• Always use the special red battery and ground
wire [RD-223], which is sold separately. Connect
the battery wire directly to the car battery positive
terminal
(+)
and the ground wire to the car body.
1. Pass the battery wire from the
engine compartment to the interior
of the vehicle.
• After making al1 other connections to the
amplifier, connect the battery wire terminal of
the amplifier to the positive
(+)
terminal of
the battery.
Engine
Fuse (30 A) compart-
ment
o
/
'\
Fuse (30 A)
Drill a 14 mm
Positive terminal
~1/2
in.)
hol~
Insert the O-ring rubber
mto the vehIcle
grommet into the vehicle body.
body.
2. Twist the battery wire, ground wire
and system remote control wire.
3. Attach lugs to wire ends. Lugs not
supplied.
• Use pliers, etc., to crimp lugs to wires.
4. Connect the wires to the terminal.
• Fix the wires securely with the terminal
screws.
GND terminal
Power terminal/System remote
\ _
~k-~~..
control terminal
~. ~'"
':'.M
!
I~ I~
•
~~~
.)~
System remote
___\
';"~~
control wire
\
Ground wire
ENGLISH
A
WARNING
Failure to securely fasten the battery wire to the ter-
minal using the terminal screws could cause the ter-
minal area to overheat and could result in damage
and injury including minor bums.
Connecting the Speaker Terminals
1. Expose the end of the speaker wires
using nippers or a cutter by about
10 mm (3/8 in.) and twist.
2. Attach lugs to speaker wire ends.
Lugs not supplied.
• Use pliers, etc., to crimp lugs to wires.
3. Connect the speaker wires to the
speaker terminals.
• Fix the speaker wires securely with the termi-
nal screws.
Speaker terminal
Speaker wire
Advertisement
Table of Contents
