Dell ST2220T User Manual page 20

Vertical Position
Sharpness
Pixel Clock
Phase
Dynamic Contrast
Response Time
Reset Display Settings
AUDIO SETTINGS
Audio Setting mode
submenu
Speaker Volume
Line Out Source
Power Save Audio
Reset Audio Setting
Exit Menu
Use the and buttons to adjust image up and down (min 0 ~ max 100).
NOTE: When using DVI or HDMI source, the Vertical Position setting is not available.
Allows you to increase or decrease the sharpness of the image.
Use and buttons to adjust the sharpness from '0' to '100'.
T he Phase and Pixel Clock adjustments allow you to adjust your monitor to your preference. These settings are accessed through the
main OSD menu, by selecting 'Display Settings'.
Use the and buttons to adjust for best image quality.
If satisfactory results are not obtained using the phase adjustment, use the Pixel Clock (coarse) adjustment and then use Phase
(fine).
NOTE: Pixel Clock and Phase Adjustments are only available for "VGA" input.
The dynamic contrast helps get a higher contrast if you choose Game preset, Movie preset, Sports preset, and Nature preset.
Use the button to enable the Dynamic Contrast adjustment.
Use the button to disable the Dynamic Contrast adjustment.
NOTE: Brightness control is disabled in Dynamic Contrast mode.
Response time is the time required for an LCD pixel to change from fully active (black) to fully inactive (white), then back to fully active
again.
You can set the response time to:
Normal
l
Overdrive (default).
l
Resets the monitor's display settings to the factory defaults.
Use the Audio Settings menu to adjust the audio settings.
Adjust the volume of the speaker.
Select the source of the audio input.
Allows you to turn on or off the power to the audio during the audio power save mode.
Default is "On".
On — Allows you to turn off the line-out to the sound bar when the monitor is in standby mode.
Off — Allows you to turn on the line-out to the sound bar when the monitor is in standby mode.
Resets your monitor audio settings to the factory defaults.
Press the button to exit the OSD main menu and Press the button to accept changes.