SEWING AN EMBROIDERY PATTERN
■ Embroidery Needle Plate Cover
Under some conditions, based on the type of fabric,
stabilizer, or thread being used, there may be some
looping in the upper thread. In this case, attach the
included embroidery needle plate cover to the
needle plate. Attach the cover by inserting the two
projections on the underside of the cover into the
notches on the needle plate as shown below.
To remove the embroidery needle plate cover, place
your fingernail in the groove and lift the plate out.
• Push the embroidery needle plate cover as far
as possible to attach it. If the embroidery
needle plate cover is not securely attached, it
may cause the needle to break.
• Do not use the embroidery needle plate
cover for any applications other than
Sewing Embroidery Patterns
a Embroidery color order
• The [+] cursor moves over the pattern,
showing which part of the pattern is being
Thread the machine with thread for the first
color, pass the thread through the hole in
embroidery foot, pull out some thread to
give it some slack, and then lightly hold the
end of the thread in your left hand.