Threading The Machine; Winding The Bobbin - Brother 885-X01 Operational Manual

KNOWING YOUR SEWING MACHINE — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

THREADING THE MACHINE

Winding the bobbin

CAUTION
●
We designed the bobbin that comes with this machine. If you use bobbins from other models,
the machine will not work properly. Only use the bobbin that comes with this machine or
bobbins of the same type (part code: SA156, SFB: XA5539-151). Using other bobbins may
cause damage to the machine.
(7/16 inch)
1
1 Pull the thread
in completely.
1 Pre-tension disk
Pull up the spool pin and put a spool of
1
thread on this pin.
While holding the thread from the spool
2
with your right hand, pass the thread
toward you, in the groove on the thread
guide. Then, pass the thread around the
pre-tension disk and pull the thread in
completely.
11
11.5 mm
This model
2 Bobbin winder shaft
Actual size
Other models
3 Bobbin
1
1 Pre-tension disk
CAUTION
●
If the spool of thread is in the wrong
place, or is set incorrectly, the thread
may tangle on the spool pin.
2
3