Removing Monitor Base - Fujitsu B24W-5 ECO Operating Manual

Getting started

Removing monitor base

Before you can use a swivel arm or a wall bracket, you must remove the monitor base.
The display surface is susceptible to scratching!
For instructions on how to mount the swivel arm or wall bracket, please see
the documentation for the swivel arm or wall bracket.
Assemble wall bracket (optional)
For further information, please see the documentation regarding the VESA FPMPMI wall bracket.
Only use UL-approved fastening brackets with a minimum load bearing capacity of 4.9 kg.
Observe the correct hole spacing (distance between screws) of 100 mm x 100 mm.
Only use M4 x 10 mm screws.
► Attach the fastening bracket to the wall bracket.
► Mount the monitor on the wall in accordance with the documentation regarding
the VESA FPMPMI wall bracket.
10
► Switch off the monitor and pull the power
plug out of the power socket.
► Lay the monitor on its face on a soft surface.
► Remove the cover and disconnect all cables.
► Remove the screws (1) on the rear
of the monitor.
You can now mount a swivel arm or
a wall bracket as per VESA FPMPMI
with 100 mm hole spacing.
A26361-K1334-Z220-1-7619, edition 1