Brother 884-639 Operation Manual page 14

� Place the thread end so that it does
not protrude from the bobbin.
While holding the end of the thread,
7
step on the foot controller for a few
seconds. Once enough thread has
wound itself around the bobbin
to hold itself in place, release the
foot controller and trim the excess
thread.
Cut thread and remove bobbin.
A
12
Press down
Pedal
Controller
� Pressing down on the controller
harder increases the winding speed.
Start winding the bobbin again by
8
pressing down on the foot controller.
Stop winding process when
9
bobbin is full. Take the foot off foot
controller.
Bobbin Winding Clutch
Manually move bobbin winding
0
clutch back to original position.