Network Settings And Infolink; Network Connection - Cable - Samsung 750 series User Manual

Network Settings and InfoLink

To access Samsung's Infolink network feature, you must make one of the connections on the following pages.

Network Connection - Cable

LAN Connection for a DHCP Environment
The procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below. Since an
IP address, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do not have to enter
them manually.
The Modem Port
on the Wall
You can connect the LAN via a Sharer (Router).
The Modem Port
on the Wall
You can connect the LAN port and the TV directly depending on your network status.
The LAN Port
on the Wall
The terminals (the position of the port and the type) of the external device may differ depending on the manufacturer.
➣
If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on again after at least 10
➣
seconds and then try again.
For the connections between the external modem and the Sharer (Router), refer to the owner's manual of the
➣
corresponding product.
You can connect the TV to the LAN directly without connecting it through a Sharer (Router)
➣
You cannot use a manual-connection-type ADSL modem because it does not support DHCP. You have to use an
➣
automatic-connection-type ADSL modem.
External Modem
(ADSL/VDSL/Cable TV)
LAN
1
Cable
Modem Cable
2
IP Sharer
External Modem
LAN Cable
(ADSL/VDSL/
Cable TV)
LAN Cable
Modem Cable
LAN Cable
TV Rear Panel
TV Rear Panel
TV Rear Panel
English - 105
1.
Connect the
[LAN] port on
the rear panel of
the TV and the
external modem
with a LAN Cable.
2.
Connect the LAN
port on the wall
and the external
modem with a
Modem Cable.