[Smart Remote Embedded] Or [Send To Smartphone] Is Canceled Halfway; The Shooting Screen For [Smart Remote Embedded] Is Notdisplayed Smoothly; You Cannot Use One-Touch Connection (Nfc) - Sony Cyber-shot DSC-HX400 Help Manual

Troubleshooting
[Smart Remote Embedded] or [Send to Smartphone] is
canceled halfway.
When the remaining battery level is low, [Smart Remote Embedded] or [Send to
Smartphone] may be canceled halfway. Charge the battery pack and try again.
Troubleshooting
The shooting screen for [Smart Remote Embedded] is not
displayed smoothly./The connection between this product
and the smartphone is disconnected.
Data communication between this product and the smartphone may fail due to signal
conditions. Place this product closer to the smartphone.
Troubleshooting

You cannot use One-Touch connection (NFC).

Place the (N mark) on the smartphone and the
together as possible. If there is no response, move the smartphone a few millimeters or
move the smartphone away from this product, wait more than 10 seconds, and then touch
them together again.
[Airplane Mode] is set to [On]. Set [Airplane Mode] to [Off].
Check whether the NFC function is activated on your smartphone. For details, refer to the
instruction manual of the smartphone.
Do not place any metal objects other than a smartphone near the
Do not contact two or more smartphones to this product at the same time.
If another NFC-based application is running on your smartphone, terminate that application.
Troubleshooting
Troubleshooting
Troubleshooting
Wi-Fi
Wi-Fi
Wi-Fi
(N mark) on the product as close
(N mark).
178