91-5824-70-00_ATT1480_R0
TELEPHONE OPERATION
AT THE BASE
Page/Intercom
1
Press and release to signal someone at the handset. A paging tone sounds.
When the person at the handset presses I, the handset and base can
2
communicate without tying up the phone line.
3
Press again or press o on handset to disconnect.
Base Ringer Volume Switch
Use to adjust how loudly the
base rings.
Press to return to idle state
Redial
Press to call the last
number dialed at the
base (up to 32 digits).
Flash
Access subscriber services while on a call.
Press to enter programming mode.
10
9/15/03
2:47 PM
Page 10
Display Dial
Press to dial the number
currently displayed on screen.
On steadily:
handset or base
speakerphone is in use
Flashing slowly:
a call is on hold
Hold
Press H to put a call
on hold. The IN USE
light flashes. To return to
the call, press K.
NOTE: When Hold is
active, pressing P on
handset will also return
you to the call.
Mute
Press M to
prevent your caller
from hearing you (you
can hear your caller).
Press again to deactivate.
MUTE light is on when
Mute is activated.
Speaker Volume
While on a call, use to
adjust the volume of
what you hear.
Make, Answer,
or End a Call
Press K. When
calling, use the base
keypad to dial or enter
a memory location.
SPEAKER light is on
when call is connected.
—OR—
1 Dial the number.
Use < to make
corrections.
2
Press d
to
place the call.