Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
For Two-Piece Toilets with Aquameter™ Fill Valve
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this
product is installed properly, please read these instructions carefully before you begin. (Certain installations may
require professional help.) Also be sure your installation conforms to local codes
!
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY
HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
RECOMMENDED TOOLS AND MATERIALS
Putty Knife
Regular Screwdriver
Hacksaw
Wax Ring/Gasket
1
REMOVE OLD TOILET
a.
Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b.
Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!
c.
Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d.
Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean and level before new toilet is installed!
2
ROUGHING-IN DIMENSIONS:
NOTE: Distance from wall to closet flange centerline must
be as listed below:
FINISHED WALL
12
(305mm)
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A m e r i c a n S t a n d a r d I n c .
© A m e r i c a n S t a n d a r d I n c . 2 0 0 6
REPERTOIRE 2266/2483
HERITAGE 2176
ANTIQUITY 2264/2464
WILLIAMSBURG 2264.702
Adjustable Wrench
Flexible Supply Tube
SUPPLY AS
REQUIRED
FINISHED
FLOOR
Sealant
Tape Measure
Closet Bolts
Carpenters Level
3
CLOSET FLANGE
CLOSET BOLTS
INSTALL CLOSET BOLTS
Install closet bolts in flange channel, turn 90˚,
and slide into place 6" (152 mm) apart and
parallel to wall.
12"
(305mm)
Saniwares
730489- 10 0 Re v. B
Advertisement
Related Manuals for American Standard Two-Piece Toilets With Aquameter Fill Valve 2264.702
Summary of Contents for American Standard Two-Piece Toilets With Aquameter Fill Valve 2264.702
-
Page 1: Installation Instructions
For Two-Piece Toilets with Aquameter™ Fill Valve Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes... - Page 2 WAX RING SEALANT POSITION TOILET ON FLANGE a. Unplug floor waste opening and install toilet on closet flange so bolts project through mounting holes. b. Loosely install mounting clip (for Heritage only), retainer washers and nuts. Side of washers marked "THIS SIDE UP" must face up! c.
- Page 3 WARNING: Do not use in-tank cleaners. Products containing chlorine (calcium hypochlorite) can seriously damage fittings in the tank. This damage can cause leakage and property damage. American Standard shall not be responsible or liable for any tank fitting damage caused by the use of cleaners containing chlorine (calcium hypochlorite).
-
Page 4: Troubleshooting Guide
For service under this warranty, it is suggested that a claim be made through the contractor or dealer from or through whom the product was purchased, or that a service request (including a description of the product model and of the defect) be sent to the following address: In the United States: American Standard Inc. P.O. Box 6820 Piscataway, New Jersey 08855...