Memory Options; Interleaving And Non-Interleaving Memory Configuration; Installing Dimms - HP ProLiant ML100 Series User Manual

Secure the media bay screws.
13.
Close the media bay retainers.
14.

Memory options

For server-specific memory installation guidelines, refer to the installation sheet that ships with the server.

Interleaving and non-interleaving memory configuration

This server supports both interleaving and non-interleaving memory configurations. Interleaving memory
increases bandwidth by allowing simultaneous access to more than one block of data (for example,
overlapping Read-Writes). This is accomplished by dividing the system memory between pairs of DIMMs and
Writing-Reading blocks of data to/from both simultaneously. In order to take advantage of memory
interleaving, identical DIMMs must be installed in pairs. DIMMs can also be installed singularly in slot 1 only
if memory interleaving is not desired.

Installing DIMMs

Power down the server (on page 6).
1.
Extend the server from the rack, if applicable.
2.
Remove the access panel
3.
Open the DIMM slot latches.
4.
("Access panel" on page 11).
Hardware options installation 41