Sas Or Sata Hard Drive Options - HP ProLiant ML100 Series User Manual

CAUTION:
completely close the processor locking lever.
Install the heatsink and the heatsink fan. For more information, see the server installation sheet.
7.
Install the access panel.
8.

SAS or SATA hard drive options

Some HP ProLiant 100 Series servers support SAS and SATA drives depending on the controller
configuration.
ProLiant server
ProLiant ML110 G4 and G5 Servers
ProLiant ML115 and ML115 G5
Servers
ProLiant ML150 G3 Server
ProLiant ML150 G5 Server
For optimal performance, avoid mixing SAS and SATA hard drives.
CAUTION:
all bays are populated with either a component or a blank.
IMPORTANT:
number. For device numbering and drive installation guidelines, refer to "SAS and SATA hard
drive guidelines (on page 59)."
IMPORTANT:
SAS or SATA Smart Array controller is installed. For more information, see the installation sheet
that ships with the server.
To install the component:
Power down the server (on page 6).
1.
Open the bezel, if applicable.
2.
To prevent possible server malfunction or damage to the equipment, be sure to
SATA support
Embedded
Embedded
Embedded
Embedded
To prevent improper cooling and thermal damage, do not operate the server unless
If only one hard drive is installed, install it in the bay with the lowest device
Some ProLiant 100 Series servers support hot-plug functionality when an optional
SAS support Maximum drives
Optional HBA 4
Optional HBA 4
Optional HBA 6
Optional HBA 8
Hardware options installation 20