Checking The Rear Hub Rubber Dampers - KTM 1190 Adventure EU Owner's Manual

15 WHEELS, TIRES
15.5

Checking the rear hub rubber dampers

Info
The engine power is transmitted from the rear sprocket to the rear wheel via 6 rubber dampers. The rubber dampers wear out dur-
ing operation. If the rubber dampers are not changed in time, the rear sprocket carrier and the rear hub will be damaged.
–
Push the wheel spindle in all the way and mount chain adjuster
Info
Mount chain adjusters
–
Push the rear wheel forward so that the chain adjusters are in contact with the tension-
ing screws, and tighten nut
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and right
S00288-10
chain adjusters must be in the same position relative to the reference marks
Nut, rear wheel spindle
–
Insert wheel speed sensor
Guideline
Remaining chassis screws
–
Operate the foot brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
S00289-10
x
3 4
and in the same position.
5
.
M25x1.5 90 Nm
(66.4 lbf ft)
6
into the hole. Mount and tighten screw
M6
143
4 and nut 5 .
B
.
Thread greased
7
.
10 Nm (7.4 lbf ft)