Starting & Stopping the Engine
Flooded Engine
If the engine fails to start after repeated attempts, it may be flooded with
excess fuel. To clear a flooded engine:
1.
Leave the engine stop switch set to RUN (
2.
Move the choke lever to the fully OFF position.
3.
Open the throttle fully.
4.
Press the start button for 5 seconds.
5.
If the engine starts, quickly close the throttle, then, if idling is
unstable, open it slightly.
If the engine does not start, wait 10 seconds, then follow the
Temperature
If the engine still won't start, refer to
Start,
page
166
How to Stop the Engine
Normal Engine Stop
To stop the engine, make sure the transmission is in neutral by checking
that the neutral indicator lights, and turn the ignition switch OFF (
The engine stop switch should normally remain in the RUN (
position even when the engine is OFF.
If your ATV is stopped with the engine stop switch OFF (
ignition switch ON (
Emergency Engine Stop
To stop the engine in an emergency, use the engine stop switch. To
operate, move the switch to either OFF (
procedure (page
.
), the battery will discharge.
49
).
If Your Engine Quits or Won't
) position.
Basic Operation & Riding
).
) and the
High Air
).
)
51