Error Rate; Caution - Epson SMD-100 series Specification

7-2-3
Specification change
The lighting condition of the IN USE LED can be changed
by means of
a short plug. Use it in a desired setting
position.
7-3
Error ratt;
The error rateof the specifications is the value with the
:f
a u 1 t 1 e s s dis
le
e t
t
e .
Well chosen diskettes must be subjected to the error rate
test.
7 -4
Cauti.on
Tha drive design has taken into consideration the external
noise
oi'
CHT, etc. Bowever, do not use it too close to
the CRT
\~ithout
perfect shielding; otherwise, the Read/
Write capability of' the drive will be doteriorated.
7-5
Installation of' drive
7-5-1
Install the drive securely, usine the four screw
holes
(M3,
PO.5,
6
DEEP) on the drive side or the
four screw holes
(M3,
~O.5.
6
DEEP) on the drive
bottom.
7-5-2
Sincc the tolüranc e of the intervals of the instal­
lation screw holes i5 ~O.2mm, ample care must bo
exercised in ensurine the positional accuracy and
bore accuracy.
7-6
Heat generation
Relative positions must be designed with such care that
th~ ambient temperature of the drive hecomes the operating
temperature of the specifications. The upper limit tem­
perature must be strictly observed particularly about the
diskette.
23