Administrator Settings - D-Link DIR-600 User Manual

Section 3 - Coniguration
This page will allow you to change the Administrator and User passwords. You can also enable Remote Management.
There are two accounts that can access the management interface through the web browser. The accounts are admin
and user. Admin has read/write access while user has read-only access. User can only view the settings but cannot
make any changes. Only the admin account has the ability to change both admin and user account passwords.
Enter a new password for the Administrator Login Name.
The administrator can make changes to the settings.
Remote
Remote management allows the DIR-600 to be
Management:
configured from the Internet by a web browser. A
username and password is still required to access the
Web-Management interface. In general, only a member
of your network can browse the built-in web pages to
perform Administrator tasks. This feature enables you to
perform Administrator tasks from the remote (Internet)
host.
Remote Admin
The port number used to access the DIR-600.
Port:
Example: http://x.x.x.x:8080 whereas x.x.x.x is the
Internet IP address of the DIR-600 and 8080 is the port
used for the Web Management interface.
D-Link DIR-600 User Manual

Administrator Settings

34