Pppoe (Dsl) - D-Link DIR-600 User Manual

Section 3 - Coniguration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide
you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE
software from your computer. The software is no longer needed and will not work through a router.
Select PPPoE (Username/Password) from the drop-
Connection:
down menu.
Address Mode:
Select Static if your ISP assigned you the IP address,
subnet mask, gateway, and DNS server addresses.
In most cases, select Dynamic.
IP Address:
Enter the IP address (Static PPPoE only).
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then retype the
password in the next box.
Service Name:
Enter the ISP Service Name (optional).
Reconnection Mode:
Select either Always-on, On-Demand, or Manual.
Maximum Idle Time:
Enter a maximum idle time during which the Internet
connection is maintained during inactivity. To disable
this feature, enable Auto-reconnect.
DNS Addresses:
Enter the Primary and Secondary DNS Server Addresses (Static PPPoE only).
MTU:
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your speciic ISP. 1492 is the default
MTU.
MAC Address:
The default MAC Address is set to the Internet port's physical interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address unless required by your ISP. You can use the Clone Your PC's
MAC Address button to replace the Internet port's MAC address with the MAC address of your Ethernet card.
D-Link DIR-600 User Manual

PPPoE (DSL)

17