Samsung SMART TV E-Manual page 153

Anynet+ (HDMI-CEC)
There is something
wrong with the TV.
Anynet+ does not
work.
I want to start
Anynet+.
I want to exit Anynet+.
The message
"Connecting to
Anynet+ device..."
or "Disconnecting
from Anynet+ device"
appears on the screen.
The Anynet+ device
won't play.
The connected device
is not displayed.
The TV audio is not
being played through
the receiver.
Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+
devices only.
Only one external device may be connected to Receiver.
Check if the power cord of the Anynet+ device is properly connected.
Check the cable connections of the Anynet+ device.
System
Navigate to the
Check whether the TV remote control is in TV mode.
Check whether the remote control is Anynet+ compatible.
Anynet+ may not function under certain circumstances. (Searching channels,
operating Smart Hub or Setup, etc.)
If you have disconnected and then reconnected the HDMI cable, scan for devices
again or turn your TV off and on.
Check if the Anynet+ device is properly connected to the TV and then navigate to
System
the menu to see if
간편메뉴
After checking, press
a device.
View TV
Select from the Anynet+ menu.
Select a non-Anynet+ device from Source.
Users cannot use the remote control when you are configuring Anynet+ or
switching to a viewing mode. Use the remote control after the TV has completed
the Anynet+ configuration or has switched to a viewing mode.
Users cannot use the play function when
Check whether the device supports Anynet+.
Check whether the HDMI cable is properly connected.
System
Navigate to the
Scan for Anynet+ devices again.
Anynet+ devices must be connected to the TV using an HDMI cable. Make sure the
device is connected to your TV with an HDMI cable. Some HDMI cables may not
support Anynet+.
If the connection is terminated because there has been a power failure or the HDMI
cable has been disconnected, please scan for the device again.
Connect an optical cable to the TV and the receiver.
ARC enables digital sound to be output via the HDMI (ARC) port.
However, ARC is only available when the TV is connected to an audio receiver that
supports ARC.
Try this!
Anynet+ (HDMI-CEC)
menu and verify that
Anynet+ (HDMI-CEC)
Anynet+ (HDMI-CEC)
button, select
Setup
Anynet+ (HDMI-CEC)
menu and verify that
is set to On.
is set to On.
and then choose
is progress.
is set to On.