Download  Print this page

Operating The Single Surface Radiant Elements - Electrolux Electric Cooktop Use & Care Manual

Electric cooktop
Hide thumbs

Advertisement

OPERATING THE SINGLE SURFACE RADIANT
ELEMENTS
The cooktop has single radiant surface elements at 2 locations; the right and left
rear (Figs. 1 & 2) element positions.
To Operate the Single Surface Element
1. Place correctly sized cookware on the radiant surface element.
2. Touch and hold the
above the
seconds the request to Power ON the cooktop will clear.
3. Touch and hold the
beep is heard. The display will show " -- ".
Note: If no further pads are touched within 10 seconds the request
to power the element ON will clear.
4. Touch
pad once for Lo.
5. Each touch of the
power level from 9.0 through 3.0 by .5 increment. Simmer power
levels between 3.0 and 1.0 will decrease or increase by .2
increment. Lo is the lowest power level available.
Note: The power level may be adjusted at any time while the element is ON.
6. When cooking has been completed touch the
and if no other surface element is used touch the
Each surface element provides a constant amount of heat at each setting. A glowing
red surface heating area extending beyond the bottom edge of the cookware indicates
the cookware is too small for the surface heating area.
Note: The HE message will remain ON if the cooktop is still hot and will remain ON until
the heating surface area has cooled sufficiently.
CA
CA
CA
CA
CAUTION
Radiant surface elements may appear to have cooled after they have been turned OFF. HE (Hot Element)
message will turn ON and will continue to glow until the glass cooktop has cooled down to a moderate
level. The glass surface may still be hot and burns may occur if the glass surface is touched before the
indicator light has turned OFF.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on
top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons
could catch fire if placed too close to the surface elements.
On/O ff
O O n/Off
POWER
On/Off
Setting Surface Controls
key pad until a beep sound. The power indicator light
POWER
will turn ON. Note: If no other key pad is touched within 20
POWER
pad for the desired element position until a
On/Of f
pad once to turn ON the power level to HI. Touch
or
pad will decrease or increase the
UTION
UTION
UTION
UTION
pad once to turn the element OFF
On/Off
key pad to turn off the cooktop.
POWER
13
Fig. 1
Fig. 2

Advertisement

loading

  Also See for Electrolux Electric Cooktop