Rear - D-Link DVS-210-1 User Manual

Section 3 - Configuration

Rear

DI/DO Ports
Status LED
Audio Out
Reset
Audio In
Video In
Audio In:
This standard 3.5mm stereo jack accepts a connection from a microphone or any suitable analog audio input source.
Audio Out:
This standard 3.5mm stereo jack accepts a connection from a speaker or any suitable analog audio output device.
Video In:
This standard BNC analog video connector accepts a connection from any suitable analog video device. An adapter may be required
when using some types of video cables.
DI/DO Ports:
This pin block includes two sets of digital input connector pairs, one digital output pair, and one RS-485 pair for PTZ control.
Reset Button:
This button can be used to restore the factory default settings. To reset the device to factory defaults, use an unfolded paperclip to press and
hold the button for at least 15 seconds until the power LED stops blinking. The device will reboot automatically after it has been reset.
Status LED:
When solidly lit, this LED indicates that the the device is initializing. When blinking, this LED indicates that the device has acquired an IP
address.
D-Link DVS-210-1 User Manual 7