Alarm suppression tab
You must first create a new alarm group in order to suppress alarms in
Surveillance Mode.
1. Click on New alarm group.
2. Add all alarms belonging to the group.
3. Finally, define under which circumstances no alarms are to be displayed by
selecting the respective checkbox if the alarm should be suppressed (digital
input open or closed).
Input devices tab
See chapter Activating input devices (page 45).
4.1.4
Activating input devices
In the Client configuration under Input devices, all input devices including
joysticks are displayed that are connected and available to the respective system
before the startup of the SeeTec client.
Any device combination is supported. Any device can be configured independent of
another device.
Special cases and restrictions
Jog dial and shuttlewheel are supported for the Axis control unit T831x in
Archive Mode.
Up to 112 virtual buttons can be configured for the Axis control unit T8312.
To do so, activate the Virtual buttons activated option. The control unit
has nine keys. If you wish to configure key 56, press keys 5 and 6 in quick
succession and select the desired action. In the Timeout (ms) field, enter
the time range in which the two buttons must be pressed.
The Videotec DCZ control unit is supported with the following restrictions:
Only 32 of the 38 buttons can be used.
Only the outer jog dial is available in the Archive mode.
Note
Each joystick requires calibration once. This must be done in the
Windows
PTZ control is only available if you select the PTZ control option in
the Camera configuration.
®
Control panel.
NVR Software - SeeTec client
45