System Events - SUPERLOLUX NI525A User Manual

System events

To react flexibly to different system events, you can send different messages to
different recipients and/or via SNMP.
1. Select the time for the daily report.
The e-mail with the report of all events that occurred during the last 24 hours will
be sent to all e-mail addresses you have specified in the E-mail management
dialog under System addresses.
The e-mail with the respective event is sent immediately when the event occurs. To
reduce e-mail traffic to a minimum, the e-mail service is equipped with flood
protection. The flood protection function ensures that e-mails are not sent
continuously but only after the time range you have specified in the Dead time (s)
field.
2. Select the E-mail recipient to which the e-mail is to be sent.
You can create the e-mail lists in the E-mail management.
3. Optional: Enable In report only to send the event only in the report e-mail
at the specified time. Click on the Select all button below the table to select
all events for report sending.
4. Optional: Enable SNMP to send the event to an SNMP server. Click on the
Select all button below the table to select all events for sending via SNMP.
You can configure the SNMP server under System Management > SNMP server.
5. Optional: If you want the event to be displayed in Surveillance Mode as
well, select the respective user or group in the Display in client field.
The results will be given in the System events field, see chapter Layer menu
(page 50).
6. Optional: In the Action column in the row of an event, click on the Edit
button to trigger an action when this event occurs. You can only select one
action per event. Click on the OK button to confirm the selection. Click on
the Edit all button below the table to select the same action for every event.
NVR Software - SeeTec Surveillance
131