Making A Recording; Making An Audio Or A Video Recording - RCA Audio/Video Receiver Owner's Manual

MAKING A RECORDING

MAKING AN AUDIO OR A VIDEO RECORDING

The following steps show you how to make an audio or a video recording from the built in tuner, or from
an audio or video source connected to the receiver (such as a CD player or TV). Recordings can be made
to a CD-Recorder, cassette deck, MD, VCR, or DVR deck connected to the CD-R/TAPE/MD, VCR or DVR
in/out connectors.
The receiver's volume, balance tone (bass, treble, loudness), and surround effects (Dolby Pro
memo
Logic/Dolby Digital and DSP settings) have no effect on the recorded signal.
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR
CD-R/
RECEIVER TUNER
TAPE/MD
2
DSP MODE MIDNIGHT 5.1CH
1 2 3
CHANNEL TEST
SELECT TONE ATT
5 6 7
CHANNEL
EFFECT
LEVEL
‡
9 0
10
FUNC
POWER
TV CONTROL
VOL
FQ
ST
ENTER
MENU
FQ
SOURCE CLASS MPX
7 8
POWER
D.ACCESS CHANNEL
1 ¡ 4
1 LOUDNESS FUNCTION MUTING
FL REMOTE
RECEIVER
DIMMER SETUP
POWER
PREPROGRAMMED
AUDIO/VIDEO SYSTEM REMOTE OSR
1
MONITOR
1 Press the MULTI CONTROL button on the remote control of the
source component .
Make sure the DIRECT FUNCTION is ON (see p, 24).
All functions except MONITOR are accessible from the remote
CD
control.
TV CONT
On the receiver, select the source directly using the front panel
4
SIGNAL
buttons.
SELECT
8
2 Prepare the program source.
ENTER
DISC
Tune to the radio station, load the CD, etc. For a video
CH
VOL
recording load the video, DVD etc.
ST
3 Insert a blank tape, MD, video etc. into the recording device
TOP
MENU
connected to either CD-R/TAPE/MD or VCR/DVR and set the
BAND
recording levels.
3
Refer to the instructions that came with the recorder if you are
¢
unsure how to do this.Most video recorders set the audio
MASTER
VOLUME recording level automatically—check your video's instruction
manual if you are unsure whether yours has manual controls.
4 Start recording, then start playback of the source component.
Record MONITOR
You can listen to (monitor) the recording as it's being made using
the MONITOR button on the the front panel if your recording
components are connected to the CD-R/TAPE/MD input (a cassette
deck would have to have a record monitor function).
Press the MONITOR button to switch between the recorded signal
and the original source signal.
37