Table of Contents
Advertisement
Figure 3.7
Caution: You need to replace the fan module within five minutes. If you do not, the
I/O modules are shut down automatically to prevent overheating of the modules.
If this occurs, turn off the chassis and turn it on again.
To install a fan module:
1
Remove the existing fan module.
a
Loosen the fastening screws.
b
Gently pull the module towards you.
2
Position the module in the slot with the screws to the right side of the chassis
(see Figure 3.7).
3
Gently slide the module in.
4
Gently tighten the screws.
Avaya P460 Installation and Maintenance Guide
Chapter 3
Installing the Avaya P460 Fan Module
M 48
0- FA
N
Avaya P460 Chassis and Module Installation
13
Advertisement
Table of Contents
