C360 Rear Panel - Avaya C360 Installation And Configuration Manual

Table 3: C360 Function LED Descriptions 3 of 3
LED
Name
PoE*
*C360-PWR only
Tip:
All LEDs light during a reset.
Tip:
Table 4: C360 Right and Left Select buttons
On order to...
Select the function
LED (see
Reset the switch
Reset the stack

C360 Rear Panel

The C360 rear panel contains a stacking module slot, AC power input and BUPS DC input.
Note:
The C/S: and SW versions on your C360 switches may differ from those shown in
Note:
Figure
Description
Power over
Ethernet.
Press...
Left or Right button
Table 3)
Both Right and Left buttons together for approximately
one second. All LEDs on the switch remain lit until the
procedure is complete.
Both Right and Left buttons together for five seconds. All
LEDs on the stack remain lit until the procedure is
complete.
7.
LED Status
OFF - PoE disabled for this port
ON - PoE is enabled and power is being supplied
to an end-station
Blinking:
PoE enabled, but no powered device is
●
detected, or
Power supply error, or
●
Not enough power
●
C360 Rear Panel
3 of 3
Issue 1 July 2006 33