Table 35: Troubleshooting 3 of 3
Problem/Cause
Stacking not functioning
Tip:
Use the stack health command to display the status
Tip:
of the stack. See
information.
X360-STK modules
●
not inserted correctly
(LEDs on stacking
module do not light)
Octaplane cables not
●
installed correctly
(LEDs on stacking
module do not light)
The pins on the
●
Octaplane cable are
bent or broken
The socket on the
●
stacking module is
damaged
NVRAM INIT jumper is
●
bridged
Suggested Solution
Stack Health
on page 204 for further
Check that modules are installed
●
correctly
Check that the cables are
●
inserted correctly
Check that there are no
●
cross-corrections
Replace the cable
●
Replace the stacking module
●
Remove the stacking module and
●
then unbridge the jumper.
Troubleshooting the Installation
3 of 3
Issue 1 July 2006
203