Paper Specifications; Paper Output Capacity; Printer And Paper Storage Environment - Dell 2355dn User Manual

Laser mfp
Hide thumbs Also See for 2355dn:
Table of Contents

Advertisement

Paper Specifications

Category
Acid Content
Caliper
Curl in Ream
Cut Edge Conditions
Fusing Compatibility
Grain
Moisture Content
Smoothness

Paper Output Capacity

Output Location
output tray (Face Down)
rear door (Face Up)

Printer and Paper Storage Environment

Paper storage environmental conditions directly affect the feed operation.
Ideally, the printer and paper storage environment should be at or near room temperature, and not
too dry or humid. Remember that paper is hygroscopic; it absorbs and loses moisture rapidly.
Heat works with humidity to damage paper. Heat causes the moisture in paper to evaporate, while
cold causes it to condense on the sheets. Heating systems and air conditioners remove most of the
humidity from a room. As paper is opened and used, it loses moisture, causing streaks and
smudging. Humid weather or water coolers can cause the humidity to increase in a room. As
paper is opened and used it absorbs any excess moisture, causing light print and dropouts. Also, as
paper loses and gains moisture it can become distorted. This can cause paper jams.
Care should be taken not to purchase more paper than can be used in a short time (about 3
months). Paper stored for long periods may experience heat and moisture extremes, which can
cause damage. Planning is important to prevent damage to large supplies of paper.
Unopened paper in sealed reams can remain stable for several months before use. Opened
packages of paper have more potential for environment damage, especially if they are not
wrapped with a moisture-proof barrier.
Specifications
5.5 pH or lower
0.094-0.18 mm (3.0-7.0 mils)
Flat within 0.02 in. (5 mm)
Cut with sharp blades with no visible fray.
Must not scorch, melt, offset or release hazardous emissions when
heated to 180° C (356° F) for 0.1 second.
Long Grain
4%-6% by weight
100-400 Sheffield
Capacity
2
150 sheets of 75 g/m
2
1 sheet of 75 g/m
bond (20 lb) paper
bond (20 lb) paper
339

Advertisement

Table of Contents
loading

Table of Contents