Items Provided; Cabinet Dimensions - Maytag 9700 series Installation Instructions Manual

Tools needed for installation
Proper installation is the responsibility of the owner.
HOWEVER, SERVICE CALLS PERFORMED AS A RESULT OF POOR SET-UP, ADJUSTMENT AND
CONNECTION ARE THE RESPONSIBILITY OF THE INSTALLER.
Make sure you have everything necessary for proper installation.
1. GROUNDED ELECTRICAL OUTLET is required. See Electric Requirements.
2. POWER CORD for electric dryers (except Canada).
3. GAS LINES (if a gas dryer) must meet National and Local Codes.
4. EXHAUST SYSTEM – must be rigid metal or flexible stiff walled metal exhaust ducting. See Exhaust Requirements.

CABINET DIMENSIONS

9700 series
A. Height-overall
B. Width
C. Depth-With Dryer Door Open 90°
D. Depth
E. Bottom Vent Hole Location - From Back
To Center of Hole
Side Vent Hole - From Back To Center Of
Hole
Note:
The height of the dryer from top to floor is 38" with the leveling leg screwed all the way in. The customer can
unscrew the leg out an additional 7\8" for a total overall height of 38 7/8".
• Teflon tape or pipe
joint compound (gas only)
• Cutting knife
• Pipe wrench (gas only)
• Nut drivers
• Level
• Screw driver (standard)
• Duct tape
• Crescent wrench
INCH (CM)
38" (96.5) A. Height-overall
27" (68.6) B. Width
49-3/8" (125.4) C. Depth-With Dryer Door Open 90°
30-3/8" (77.2) D. Depth
7-1/2" (19) E. Bottom Vent Hole Location - From Back
8-1/2" (21.6)
2

ITEMS PROVIDED

Electric Dryer
Only
6700 series
To Center of Hole
Side Vent Hole - From Back To Center Of
Hole
Gas Dryer
Only
INCH (CM)
38" (96.5)
27" (68.6)
46-7/16" (123.0)
28" (71.0)
7-1/2" (19)
8-1/2" (21.6)